Features

100 Watts @ 4, 8 or 16 Ohms, selectable impedance

T-Dynamic® and presence controls

Two footswitchable channels

Footswitchable effects loop

External speaker jack

Resonance switch

High and low gain inputs

Reverb with level control

Footswitch included

3-band EQ on each channel
 
Rated Power & Load
(Power specs measured with T. Dynamics @ 10%): 100 Watts RMS into 16, 8, or 4 ohms Power @ Clipping: (typically) (5% THD, 1 kHz, 120 V AC line): 100 Watts RMS into 16, 8, or 4 ohms
Frequency Response: +0, 3 dB, 60 Hz to 20 kHz, @80WRMS
Hum & Noise: Greater than 86 dB below rated power
Power Consumption: 300 W @ 60 Hz, 120 VAC

Preamp Section
The following specs are measured @ 1kHz with the controls preset as follows:
Push Bright, Off (out)
Channel Select Normal (out)
Mid @ 0
Presence @ 0 dB
Pre & Post Gain @ 10
Gain & Thrash, Off (out)
Normal Levels are with normal volume @ 5

Minimum Levels are with normal volume @ 10 Preamp High Gain Input: Impedance: High-Z, 1 M ohm
Nominal Input Level: -14 dBV, 200 mV RMS
Minimum Input Level: -24 dBV, 60 mV RMS
Maximum Input Level: 0 dBV, 1 VRMS
Preamp Low Gain Input: Impedance: High-Z, 44 K ohms
Nominal Input Level: -8 dBV, 400 mV RMS
Minimum Input Level: -18 dBV, 120 mV RMS
Maximum Input Level: 6 dBV, 2VRMS
Effects Send: Load Impedance: 1 K ohm or greater
Nominal Output Level: -10 dBV, 0.3 V RMS or 0 dBV, 1 V RMS if Effects Level is in
Effects Return: Impedance: High-Z, 22 K ohms
Designed Input Level: -10 dBV, 0.3 V RMS or 0 dBV, 1 V RMS if Effects Level is in (Switching jack provides Effects Send to Effects Return connection when not used)
Preamp Output: Load Impedance: 1 K ohm or greater
Nominal Output Level: 0 dBV, 1 VRMS
Power Amp Input: Impedance: High-Z, 30 K ohms
Designed Input Level: 0 dBV, 1 VRMS (Switching jack provides preamp output to power amp input connection when not used)

Other
System Hum & Noise @ Nominal Input Level (20 Hz to 20 kHz un weighted): 72 dB below rated power

Equalization: Special low, mid, & high passive type EQ
- Presence: +6 dB @ 5 kHz
- Push Bright: +6 dB @ 2 kHz
- Push Thrash: -20 dB notch @ 1kHz in Lead channel
- Push Gain: Increases Lead gain
- Push Resonance: +6 dB @ cabinet resonance